Lonnie-S wrote:
I ran into a reference to this exhaust header modeling kit. Perhaps others have heard of it, but it's news to me. It is pricey. However, if you were doing it for a living, it would probably pay for itself in short order.
Attachment:
ICE-Modeling.jpg
Here is the company's website with a page that has a pretty clear video on the process involved:
How it works ==>
http://www.icengineworks.com/#!howitworks/c1seHere's a link to a kit for 4-cylinder engines ($419.99) ==>
http://www.icengineworks.com/#!online-s ... y=11578474Unless you could share it among several Locost builders, it might be too pricey for the amateur.
Cheers,
"Modeling kit ?" I don't know about States
but here in Quebec if You smile at the
owner of muffler shop, he might allow to
pick scrap stainless pipes with which a
whole exhaust system can be made.
On your picture nr1 is almost twice as
long as the nr4 and all 4 are joining
collector. Normally performance header
is 4 into 2 and 2 into 1. and all pipes
sections ought to have same length
https://www.youtube.com/watch?v=bwotGoYKo_w.
My two cents
Cheers ewhen