yes dfdahl the intake looks very close. was looking at your build i had to see if the carbs fit under the hood. i like the amount of adjustment you get with front a arms. very nice build. i just took a look but am going back to it
Thanks nick when i got the frame it had no caster. After a week of looking at a mgb front end I was getting close to a plan. Then i found your build log it was grate. When you started with a arms then built the frame i new i should try and copy your angle. i liked how you added the life story of a grinder. a 13" wheel is what i was going to try i dont think smaller is street legal in bc. i have no plan for seats yet i need one to set steering wheel. i have a go-kart seat but it looks to short.
hi hilux i saw a video of you driving and took a look at your build log. I was hoping you mite have some advice your car looks fast in the video. how do you like 20r in a 442? i think yours was stock rebuilt 20r would you add more power?
I did get some done today. if i can remember where the 4age gaskets are it would go faster. at least bolts and tools wer organized for today that ment i found them and they were in a box or pan.
Attachment:
102_1818.JPG
got trans and some parts on 4age but had to stop tell i find intake gasket and frost plugs.
Attachment:
102_1815.JPG
had to replace distributor on the 20r it got in a fight with shock tower. lucky i had 2 spare the one on the left is newer and had a better coil. the one on the right had points and rust dose still spin a bit. newer one it is i removed valve cover to set timing. it looks good in side i want a clear valve cover. all the good parts are hiding how about a clear oil pan to.
Attachment:
102_1810.JPG
Attachment:
102_1813.JPG
Attachment:
102_1814.JPG
was playing with a carb adapter for a single side draft i can make it work if carb is at back or if i make a spacer to clear thermostat then carb could be in front but it would be sticking out of hood. Got clutch, trans, motor mounts,and header on with all the bolts tight, had to stop tell i find the alternator and water pump is bent so will need a new one.
Attachment:
102_1817.JPG
this site is grate thanks for all the comments and help finding builds to look at.