Checking the radiator fit and it looks kinda tight.
Attachment:
WP_20170307_19_02_22_Pro.jpg
Attachment:
WP_20170307_19_02_42_Pro.jpg
Attachment:
WP_20170307_19_02_56_Pro.jpg
Have to cut into this vent here to get it to fit.
Attachment:
WP_20170307_19_03_17_Pro.jpg
It should work out ok though. I'm thinking about getting flexible HVAC ducting to run up to the firewall so that I can bend it around the control arms and clear everything. The vent on the otherside will feed the intake for the engine. Driver's side vent will be sealed off.
I bought a little heater unit from summit and mounted it under the dash. I'm planning to run some ducting to each defrost vent, and then a vent down towards the floor.
Attachment:
WP_20170308_18_52_23_Pro.jpg
Attachment:
WP_20170308_18_52_51_Pro.jpg
Plenty of room for everything else still.
Now here is the question: I've put the column together as shown with the original horn button.
Attachment:
WP_20170308_19_20_42_Pro.jpg
Attachment:
WP_20170308_19_21_21_Pro.jpg
Attachment:
WP_20170308_19_22_06_Pro.jpg
Attachment:
WP_20170308_19_22_30_Pro.jpg
Attachment:
WP_20170308_19_23_30_Pro.jpg
Attachment:
WP_20170308_19_23_49_Pro.jpg
Have I shorted it all out, or will this work? Barring any definitive answer, I'll have to break out the multimeter and check continuity. I'm hoping this works.