Ok in this shot you can see the rear lowers are in place.
1.jpg [ 82.55 KiB | Viewed 12738 times ]
I am using as much of the stock stuff as possible until the car is a runner,then the decision will be made as to what has to go or be upgraded.
2.jpg [ 88.67 KiB | Viewed 12722 times ]
This is a better shot of the rears
3.jpg [ 95.02 KiB | Viewed 12702 times ]
The other side.
4.jpg [ 95.98 KiB | Viewed 12685 times ]
Sitting on the trans are the strut plates out of the donor. I havent decided to use them or not.
5.jpg [ 93.43 KiB | Viewed 12690 times ]
I have several of these aluminum plastic rads in various sizes,which one am I going to use and where am I mounting it.
6.jpg [ 86.49 KiB | Viewed 12675 times ]
In the other forum I asked about using the struts in the rear and the reason for the question is If I stand the struts straight up the stiffener bar that I would have to install would block my intakes. Dont worry there is more to come as I am taking the winter off to enjoy the fruits of my hard work over the last ten years.
7.jpg [ 96.32 KiB | Viewed 12655 times ]