My Alpha Tig worked just fine right out of the box, Well, as far as I could tell. I had never TIG'd before
| LocostUSA.com https://locostusa.com/forums/ |
|
| Nice TIG https://locostusa.com/forums/viewtopic.php?f=15&t=20410 |
Page 1 of 1 |
| Author: | STranger 7 [ December 14, 2019, 1:48 pm ] |
| Post subject: | Nice TIG |
Ran across this review. https://www.youtube.com/watch?v=-YkWY3nVAlY $775.00 through Amazon. Looks promising. Ron |
|
| Author: | RoyzMG [ December 14, 2019, 3:11 pm ] |
| Post subject: | Re: Nice TIG |
Very nice and very impressive for a $775 machine. Certainly makes TIG affordable. thanks, Roy |
|
| Author: | FastG [ December 14, 2019, 3:28 pm ] |
| Post subject: | Re: Nice TIG |
I would check out the AHP welder, lots of information and reviews available online they have been available for a few years and even cheaper at $690. I had one it worked perfectly but I sold it when I moved to MD. But it looks like I will buying another one soon. The Aluminum scuttle I am planing on building will have to be made up of multiple pieces welded together, I am going to try the low temp gas bottle AL welding if that does not work then it will be another AHP. https://ahpwelds.com/catalog/tig Graham |
|
| Author: | Want2race [ December 14, 2019, 6:05 pm ] |
| Post subject: | Re: Nice TIG |
I plan to buy the original machine mentioned. I actually sold my Lincoln to make it happen. Previously I was going to go with the ahp but a friend had his hf crap out. Ahp made him send it in for repair on his fine. It was $120. Outside of that and the fact the pro tig now comes with a better foot pedal wins me over. In reality I don't think either is a bad move |
|
| Author: | slappynuts [ December 16, 2019, 8:36 pm ] |
| Post subject: | Re: Nice TIG |
FastG wrote: I would check out the AHP welder, lots of information and reviews available online they have been available for a few years and even cheaper at $690. I had one it worked perfectly but I sold it when I moved to MD. But it looks like I will buying another one soon. The Aluminum scuttle I am planing on building will have to be made up of multiple pieces welded together, I am going to try the low temp gas bottle AL welding if that does not work then it will be another AHP. https://ahpwelds.com/catalog/tig Graham My buddy bought one and it didn't work when he got it. He sent it back and they sent him a new one (three times) none of them worked. If you are looking for a cheap TIG machine, the eastwood TIG200 is my recommendation. |
|
| Author: | rx7locost [ December 16, 2019, 9:23 pm ] |
| Post subject: | Re: Nice TIG |
My Alpha Tig worked just fine right out of the box, Well, as far as I could tell. I had never TIG'd before
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|