LocostUSA.com

Thanks again for the clarifying Internet references, Ron.

Cheers,

_________________
Damn! That front slip angle is way too large and the Ackerman is just a muddle.

Build Log: viewtopic.php?f=35&t=5886

RichardSIA,
The MGB 7 frames never got off the ground. The shop space never materialized and life got in the way. etc etc
While waiting to start, I started thinking about designing a frame that would be wide enough in front to use a MGB rack without altering it.
( cutting a section out) Probably wind up looking like the 7x or this 7y

Should handle much better than a MGB. It would just look a little odd
Maybe later.
Clearing the space, where the Ranger based frame was built, to start on a series 2 size frame with the triangulation much like the Cat 165.
Ran across this Spridget powered restoration article. May be of some use to you.
http://www.simplesevens.org/2073/2073.htm
Ron

_________________
"Age is an issue of mind over matter. If you don't mind, it doesn't matter." - Mark Twain
In my defense the moon was full and I was left unsupervised

^ That's pretty cool.
Has a lot of 60s Lotus F1 vibe going for it.

_________________
1975 MG Midget
http://www.locostusa.com/forums/viewtopic.php?f=36&t=24382
13B Powered Rotus Geauxkart
http://www.locostusa.com/forums/viewtopic.php?f=35&t=20899