LocostUSA.com
https://locostusa.com/forums/

V8 SHO engine in a haynes roadster!
https://locostusa.com/forums/viewtopic.php?f=4&t=20842
Page 1 of 1

Author:  SHOcost [ February 19, 2021, 7:45 pm ]
Post subject:  V8 SHO engine in a haynes roadster!

I've been lurking on the forum for a few years and think I am finally ready to take the plunge. I am planning on shoving a ford taurus sho 3.4 v8 into a haynes roadster. From what ive looked at it should fit into the haynes roadster engine bay without any modifications but I want to double check with people who built one of these already to hear their thoughts. The engine measures roughly 22"width X 23"height X 22.5"length.

Author:  gto7419 [ February 26, 2021, 7:30 pm ]
Post subject:  Re: V8 SHO engine in a haynes roadster!

Judging from the size of my r1 cradle/motor, that shouldnt be an issue. What trans are you going to run?

Author:  SHOcost [ February 28, 2021, 10:54 pm ]
Post subject:  Re: V8 SHO engine in a haynes roadster!

gto7419 wrote:
Judging from the size of my r1 cradle/motor, that shouldnt be an issue. What trans are you going to run?


I plan on running a 5 speed out of an early 2000s Jaguar or Lincoln ls. The six cylinders had the same bolt pattern as the sho v8 so hopefully everything should line up.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/