LocostUSA.com

Learning how to build Lotus Seven replicas...together!
It is currently April 25, 2024, 2:48 pm

Board index » The North American Locost Forums » Engines and drivetrains

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
mantisMan20
PostPosted: March 23, 2021, 2:56 pm 
Offline

Joined: January 13, 2021, 5:35 pm
Posts: 10
Looking for information on adapting a T5 to a 3.0 Duratec V6,end game is front engine to rear drive.
Have the flywheel info that will fit(thanks to this forum) Need to know the part number of the pressure plate to adapt to the Ford Contour SVT (Fidenza)
lt. weight flywheel .Clutch friction plate is 9inch dia. 10 spline (Ford 2.3 l / T5 g.box)
Would appreciate any help with the p/n and or supplier, manufacturer.

many thanks.
Top
 Profile  
Reply with quote  
Laminar
PostPosted: March 23, 2021, 4:14 pm 
Offline

Joined: September 19, 2009, 12:33 pm
Posts: 498
I've had good luck calling Centerforce and talking about the diameter and bolt pattern that I need and having them recommend something that will fit the bill when I was working out how to fit up a GT500 transmission to a 351W with a truck 164 tooth flywheel.

_________________
Ford 5.0 into an M3
mikaelvroom.com | @MikaelVroom
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » The North American Locost Forums » Engines and drivetrains

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 16 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
POWERED_BY